Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual page 435

:MEASure:DUAL:VBASe
Overview
This measurement is available with the N2820A high sensitivity current
probe when both the Primary and Secondary probe cables are used. This
measurement joins the Zoom In waveform data below the probe's clamp
level with Zoom Out waveform data above the probe's clamp level to create
the waveform on which the measurement is made.
Command Syntax
:MEASure:DUAL:VBASe [<source1>][,<source2>]
<source1>,<source2> ::= CHANnel<n> with N2820A probe connected
<n> ::= 1 to (# analog channels) in NR1 format
The :MEASure:DUAL:VBASe command installs a screen measurement and
starts a waveform base value measurement.
If the optional source parameter(s) are specified, the currently specified
source(s) are modified.
Query Syntax
:MEASure:DUAL:VBASe? [<source1>][,<source2>]
The :MEASure:DUAL:VBASe? query returns the vertical value at the base
of the waveform. The base value of a pulse is normally not the same as
the minimum value.
Return Format
<base_voltage><NL>
<base_voltage> ::= value at the base of the selected waveform in
See Also •
•
•
•
•
•
•
•
•
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1208)
NR3 format
":MEASure:DUAL:CHARge"
":MEASure:DUAL:VAMPlitude"
":MEASure:DUAL:VAVerage"
":MEASure:DUAL:VPP"
":MEASure:DUAL:VRMS"
"Introduction to :MEASure Commands"
":MEASure:SOURce"
":MEASure:VTOP" on page 480
":MEASure:VMIN" on page 475
on page 432
on page 433
on page 434
on page 436
on page 437
on page 420
on page 458
21
:MEASure Commands
435