:WGEN<w>:MODulation:FUNCtion
Command Syntax
:WGEN<w>:MODulation:FUNCtion <shape>
<w> ::= 1 in NR1 format
<shape> ::= {SINusoid | SQUare| RAMP}
The :WGEN<w>:MODulation:FUNCtion command specifies the shape of the
modulating signal.
When the RAMP shape is selected, you can specify the amount of time per
cycle that the ramp waveform is rising with the
:WGEN<w>:MODulation:FUNCtion:RAMP:SYMMetry command.
This command applies to AM and FM modulation. (The FSK modulation
signal is a square wave shape.)
Query Syntax
:WGEN<w>:MODulation:FUNCtion?
The :WGEN<w>:MODulation:FUNCtion? query returns the specified
modulating signal shape.
Return Format
<shape><NL>
<shape> ::= {SIN | SQU| RAMP}
See Also
•
•
•
•
•
•
•
•
•
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see
page
1208)
":WGEN<w>:MODulation:AM:DEPTh"
":WGEN<w>:MODulation:AM:FREQuency"
":WGEN<w>:MODulation:FM:DEViation"
":WGEN<w>:MODulation:FM:FREQuency"
":WGEN<w>:MODulation:FSKey:FREQuency"
":WGEN<w>:MODulation:FSKey:RATE"
":WGEN<w>:MODulation:FUNCtion:RAMP:SYMMetry"
":WGEN<w>:MODulation:STATe"
":WGEN<w>:MODulation:TYPE"
:WGEN<w> Commands
on page 1073
on page 1074
on page 1075
on page 1076
on page 1077
on page 1078
on page 1082
on page 1083
34
on page 1080
1079