17
:FUNCtion<m> Commands
:FUNCtion<m>:BUS:SLOPe
(see
page
1208)
Command Syntax
:FUNCtion<m>:BUS:SLOPe <slope>
<m> ::= 1-4 in NR1 format
<slope> ::= {NEGative | POSitive | EITHer}
The :FUNCtion<m>:BUS:SLOPe command specifies the clock signal edge for
the Chart Logic Bus State operation.
Query Syntax
:FUNCtion<m>:BUS:SLOPe?
The :FUNCtion<m>:BUS:SLOPe query returns the clock edge setting.
Return Format
<slope><NL>
<slope> ::= {NEGative | POSitive | EITHer}
See Also
•
":FUNCtion<m>:OPERation"
on page 358
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
343