Trigger:shold:slope - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

32
:TRIGger Commands

:TRIGger:SHOLd:SLOPe

Command Syntax
:TRIGger:SHOLd:SLOPe <slope>
<slope> ::= {NEGative | POSitive}
The :TRIGger:SHOLd:SLOPe command specifies whether the rising edge or
the falling edge of the clock signal is used.
Query Syntax
:TRIGger:SHOLd:SLOPe?
The :TRIGger:SHOLd:SLOPe? query returns the current rising or falling
edge setting.
Return Format
<slope><NL>
<slope> ::= {NEG | POS}
See Also
•
•
•
•
992
(see page 1208)
"Introduction to :TRIGger Commands"
":TRIGger:MODE" on page 944
":TRIGger:SHOLd:SOURce:CLOCk"
":TRIGger:SHOLd:SOURce:DATA"
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
on page 935
on page 993
on page 994