measurement thresholds are 90%, 50%, and 10% values between Vbase and
Vtop. If you want to move the delay measurement point nearer to Vtop or
Vbase, you must change the threshold values with the :MEASure:DEFine
THResholds command.
Return Format
<value><NL>
<value> ::= floating-point number delay time in seconds in NR3 format
See Also
•
•
•
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
"Introduction to :MEASure Commands"
":MEASure:DEFine"
on page 427
":MEASure:PHASe"
on page 448
:MEASure Commands
on page 420
21
431