Save:image[:Start] - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

5
Commands by Subsystem

:SAVE:IMAGe[:STARt]

Command Syntax
:SAVE:IMAGe[:STARt] [<file_spec>]
<file_spec> ::= {<internal_loc> | <file_name>}
<internal_loc> ::= 0-9; an integer in NR1 format
<file_name> ::= quoted ASCII string
The :SAVE:IMAGe[:STARt] command saves an image.
If a file extension is provided as part of a specified <file_name>, and it does not match the
N O T E
extension expected by the format specified in :SAVE:IMAGe:FORMat, the format will be
changed if the extension is a valid image file extension.
If the extension ".bmp" is used and the current :SAVE:IMAGe:FORMat is not BMP or BMP8,
N O T E
the format will be changed to BMP.
When the <internal_loc> option is used, the :SAVE:IMAGe:FORMat will be changed to TIFF.
N O T E
See Also
•
•
•
•
•
•
•
•
360
(see page 658)
"Introduction to :SAVE Commands"
":SAVE:IMAGe:AREA"
":SAVE:IMAGe:FACTors"
":SAVE:IMAGe:FORMat"
":SAVE:IMAGe:INKSaver"
":SAVE:IMAGe:PALette"
":SAVE:FILename" on page 359
":RECall:IMAGe[:STARt]"
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
on page 358
on page 361
on page 362
on page 363
on page 364
on page 365
on page 353