Trigger:zone<N>:Mode - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

:TRIGger:ZONE<n>:MODE
Command Syntax
:TRIGger:ZONE<n>:MODE <mode>
<mode> ::= {INTersect | NOTintersect}
<n> ::= 1-2 in NR1 format
The :TRIGger:ZONE<n>:MODE command sets the zone qualifying condition
for Zone 1 or Zone 2 as either "Must Intersect" or "Must Not Intersect".
Query Syntax
:TRIGger:ZONE<n>:MODE?
The :TRIGger:ZONE<n>:MODE? query returns the zone qualifying condition
for Zone 1 or Zone 2.
Return Format
<mode><NL>
<mode> ::= {INT | NOT}
See Also •
•
•
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1208)
":TRIGger:ZONE<n>:STATe"
":TRIGger:ZONE<n>:PLACement"
":TRIGger:ZONE<n>:VALidity"
on page 1018
on page 1016
on page 1017
32
:TRIGger Commands
1015