Trigger:zone<N>:Placement - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

32
:TRIGger Commands
:TRIGger:ZONE<n>:PLACement
Command Syntax
:TRIGger:ZONE<n>:PLACement <width>, <height>, <x_center>, <y_center>
<width> ::= width of zone in seconds
<height> ::= height of zone in volts
<x_center> ::= center of zone in seconds
<y_center> ::= center of zone in volts
<n> ::= 1-2 in NR1 format
The :TRIGger:ZONE<n>:PLACement command sets the size and location of
Zone 1 or Zone 2.
No error is returned if the zone is placed off- screen, or if the zones
overlap such that Zone 2 becomes invalid. The :TRIGger:ZONE<n>:VALidity?
query is used to retrieve this information.
Query Syntax
:TRIGger:ZONE<n>:PLACement?
The :TRIGger:ZONE<n>:PLACement? query returns the size and location of
Zone 1 or Zone 2.
Return Format
<opt><NL>
<opt> ::= <width>, <height>, <x_center>, <y_center>
See Also
•
•
•
1016
(see page 1208)
":TRIGger:ZONE<n>:STATe"
":TRIGger:ZONE<n>:MODE"
":TRIGger:ZONE<n>:VALidity"
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
on page 1018
on page 1015
on page 1017