Save:arbitrary[:Start] - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

27
:SAVE Commands

:SAVE:ARBitrary[:STARt]

Command Syntax
:SAVE:ARBitrary:[STARt] [<file_spec>][, <wavegen_id>]
<file_spec> ::= {<internal_loc> | <file_name>}
<internal_loc> ::= 0-3; an integer in NR1 format
<file_name> ::= quoted ASCII string
<wavegen_id> ::= {WGEN1 | WGEN2}
The :SAVE:ARBitrary:[STARt] command saves the current arbitrary
waveform to an internal location or a file on a USB storage device.
The <wavegen_id> parameter specifies which waveform generator to save
the arbitrary waveform from.
If a file extension is provided as part of a specified <file_name>, it must be ".csv".
N O T E
See Also •
•
•
624
(see page 1208)
"Introduction to :SAVE Commands"
":SAVE:FILename" on page 626
":RECall:ARBitrary[:STARt]"
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
on page 623
on page 615