Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual page 248

8
:BUS<n> Commands
:BUS<n>:CLEar
Command Syntax
:BUS<n>:CLEar
<n> ::= An integer, 1 or 2, is attached as a suffix to BUS
and defines the bus that is affected by the command.
The :BUS<n>:CLEar command excludes all of the digital channels from the
selected bus definition.
This command is only valid for the MSO models.
N O T E
See Also •
•
•
•
•
•
248
(see page 1208)
"Introduction to :BUS<n> Commands"
":BUS<n>:BIT<m>" on page 245
":BUS<n>:BITS" on page 246
":BUS<n>:DISPlay" on page 249
":BUS<n>:LABel" on page 250
":BUS<n>:MASK" on page 251
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
on page 244