Power:transient:next - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

25
:POWer Commands

:POWer:TRANsient:NEXT

Command Syntax
:POWer:TRANsient:NEXT
The :POWer:TRANsient:NEXT command goes to the next step of the
transient analysis.
This command is equivalent to pressing the Next softkey on the
oscilloscope front panel when prompted during the analysis.
See Also
•
•
•
•
612
(see page 1208)
":POWer:TRANsient:APPLy"
":POWer:TRANsient:EXIT"
":POWer:TRANsient:IINitial"
":POWer:TRANsient:INEW"
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
on page 608
on page 609
on page 610
on page 611