Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual page 1114

36
Obsolete and Discontinued Commands
Discontinued Command
:POWer:SIGNals:DURation
:POWer:SIGNals:VMAXimum
:POWer:SIGNals:VSTeady
:POWer:SLEW:VALue
:PWRenable
:PWRRegister[:EVENt]
SYSTem:KEY
TEST:ALL
TRACE subsystem
TRIGger:ADVanced subsystem
TRIGger:TV:FIELd
1114
Current Command Equivalent
:POWer:SIGNals:DURation:EF
Ficiency (see page 584)
:POWer:SIGNals:DURation:M
ODulation (see page
:POWer:SIGNals:DURation:ON
OFf:OFF (see page 586)
:POWer:SIGNals:DURation:ON
OFf:ON (see page 587)
:POWer:SIGNals:DURation:RIP
Ple (see page 588)
:POWer:SIGNals:DURation:TR
ANsient (see page 589)
:POWer:SIGNals:VMAXimum:I
NRush (see page 592)
:POWer:SIGNals:VMAXimum:
ONOFf:OFF (see page
:POWer:SIGNals:VMAXimum:
ONOFf:ON (see page
:POWer:SIGNals:VSTeady:ON
OFf:OFF (see page 595)
:POWer:SIGNals:VSTeady:ON
OFf:ON (see page 596)
:POWer:SIGNals:VSTeady:TRA
Nsient (see page 597)
none
none
none
none
*TST (Self Test) (see
none
:TRIGger:TV:MODE (see
page 1004)
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
Comments
This command was separated
into several other commands
for specific types of power
analysis.
585)
This command was separated
into several other commands
for specific types of power
analysis.
593)
594)
This command was separated
into several other commands
for specific types of power
analysis.
Slew rate values are now
displayed using max and min
measurements of a
differentiate math function
signal.
The Power Event Enable
Register does not exist in the
4000 X-Series oscilloscopes.
The Power Event Event
Register does not exist in the
4000 X-Series oscilloscopes.
page 185)
All commands discontinued,
feature not available
Use new GLITch, PATTern, or
TV trigger modes