Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual page 924

31
:TIMebase Commands
Table 130 :TIMebase Commands Summary (continued)
Command
:TIMebase:WINDow:RANG
e <range_value> (see
page 933)
:TIMebase:WINDow:SCAL
e <scale_value> (see
page 934)
Introduction to
The TIMebase subsystem commands control the horizontal (X- axis)
:TIMebase
functions and set the oscilloscope to X- Y mode (where channel 1 becomes
Commands the X input and channel 2 becomes the Y input). The time per division,
delay, vernier control, and reference can be controlled for the main and
window (zoomed) time bases.
Reporting the Setup
Use :TIMebase? to query setup information for the TIMebase subsystem.
Return Format
The following is a sample response from the :TIMebase? query. In this
case, the query was issued following a *RST command.
:TIM:MODE MAIN;REF CENT;MAIN:RANG +1.00E-03;POS +0.0E+00
924
Query
:TIMebase:WINDow:RANG
e? (see page 933)
:TIMebase:WINDow:SCAL
e? (see page 934)
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
Options and Query Returns
<range value> ::= range value in
seconds in NR3 format for the
zoomed window
<scale_value> ::= scale value in
seconds in NR3 format for the
zoomed window