Display:clear - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

14
:DISPlay Commands

:DISPlay:CLEar

(see page 1208)
Command Syntax
:DISPlay:CLEar
The :DISPlay:CLEar command clears the display and resets all associated
measurements. If the oscilloscope is stopped, all currently displayed data
is erased. If the oscilloscope is running, all of the data for active channels
and functions is erased; however, new data is displayed on the next
acquisition.
See Also • "Introduction to :DISPlay Commands" on page 310
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 315