Sbus<N>:Flexray:source - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

28
:SBUS<n> Commands
:SBUS<n>:FLEXray:SOURce
Command Syntax
:SBUS<n>:FLEXray:SOURce <source>
<source> ::= {CHANnel<n>}
<n> ::= {1 | 2 | 3 | 4}
The :SBUS<n>:FLEXray:SOURce command specifies the input source for
the FlexRay signal.
Query Syntax
:SBUS<n>:FLEXray:SOURce?
The :SBUS<n>:FLEXray:SOURce? query returns the current source for the
FlexRay signal.
Return Format
<source><NL>
See Also
•
•
•
•
694
(see page 1208)
"Introduction to :TRIGger Commands"
":SBUS<n>:FLEXray:TRIGger"
":SBUS<n>:FLEXray:TRIGger:EVENt:TYPE"
":SBUS<n>:FLEXray:AUTosetup"
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
on page 935
on page 695
on page 699
on page 687