22
:MEASure Power Commands
:MEASure:IPOWer
Command Syntax
:MEASure:IPOWer
The :MEASure:IPOWer command installs an input power measurement on
screen.
Before sending this command or query, you must specify the channels
probing the input voltage, input current, output voltage, and output
current (using the :POWer:SIGNals:SOURce:VOLTage<i> and
:POWer:SIGNals:SOURce:CURRent<i> commands) and you must perform the
automated signals setup (using the :POWer:SIGNals:AUTosetup EFFiciency
command).
Query Syntax
:MEASure:IPOWer?
The :MEASure:IPOWer query returns the measured input power.
Return Format
<return_value><NL>
<return_value> ::= the input power value in NR3 format
See Also
•
•
•
•
496
(see
page
1208)
":POWer:SIGNals:SOURce:VOLTage<i>"
":POWer:SIGNals:SOURce:CURRent<i>"
":POWer:SIGNals:AUTosetup"
":POWer:EFFiciency:APPLy"
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
on page 599
on page 598
on page 581
on page 553