Wgen<W>:Arbitrary:interpolate - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

34
:WGEN<w> Commands
:WGEN<w>:ARBitrary:INTerpolate
Command Syntax
:WGEN<w>:ARBitrary:INTerpolate {{0 | OFF} | {1 | ON}}
<w> ::= 1 or 2 in NR1 format
The :WGEN<w>:ARBitrary:INTerpolate command enables or disables the
Interpolation control.
Interpolation specifies how lines are drawn between arbitrary waveform
points:
• When ON, lines are drawn between points in the arbitrary waveform.
• When OFF, all line segments in the arbitrary waveform are horizontal.
Query Syntax
:WGEN<w>:ARBitrary:INTerpolate?
The :WGEN<w>:ARBitrary:INTerpolate query returns the current
interpolation setting.
Return Format
{0 | 1}
See Also
•
•
•
•
1064
(see page 1208)
Voltage levels change linearly between one point and the next.
The voltage level of one point remains until the next point.
":WGEN<w>:ARBitrary:DATA"
":WGEN<w>:ARBitrary:DATA:DAC"
":SAVE:ARBitrary[:STARt]"
":RECall:ARBitrary[:STARt]"
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
on page 1060
on page 1063
on page 624
on page 615