Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual page 391

Set and query the settings of X- axis markers (X1 and X2 cursors) and the
Y- axis markers (Y1 and Y2 cursors). See
Commands"
Table 95 :MARKer Commands Summary
Command
:MARKer:MODE <mode>
(see page 394)
:MARKer:X1Position
<position>[suffix]
(see page 395)
:MARKer:X1Y1source
<source> (see
page 396)
:MARKer:X2Position
<position>[suffix]
(see page 397)
Agilent InfiniiVision 4000 X-Series Oscilloscopes
Programmer's Guide
20
:MARKer Commands
on page 392.
Query
:MARKer:MODE? (see
page 394)
:MARKer:X1Position?
(see page 395)
:MARKer:X1Y1source?
(see page 396)
:MARKer:X2Position?
(see page 397)
s1
"Introduction to :MARKer
Options and Query Returns
<mode> ::= {OFF | MEASurement |
MANual | WAVeform | BINary | HEX}
<position> ::= X1 cursor position
value in NR3 format
[suffix] ::= {s | ms | us | ns |
ps | Hz | kHz | MHz}
<return_value> ::= X1 cursor
position value in NR3 format
<source> ::= {CHANnel<n> |
FUNCtion<m> | MATH<m> |
WMEMory<r>}
<n> ::= 1 to (# analog channels)
in NR1 format
<m> ::= 1-4 in NR1 format
<r> ::= 1 to (# ref waveforms) in
NR1 format
<return_value> ::= <source>
<position> ::= X2 cursor position
value in NR3 format
[suffix] ::= {s | ms | us | ns |
ps | Hz | kHz | MHz}
<return_value> ::= X2 cursor
position value in NR3 format
391