Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual page 194

6
Root (:) Commands
For further information on :AUToscale, see the User's Guide.
See Also •
•
•
Example Code
See complete example programs at:
starting on page 1217
194
"Introduction to Root (:) Commands"
":AUToscale:CHANnels"
":AUToscale:AMODE"
' AUTOSCALE - This command evaluates all the input signals and sets
' the correct conditions to display all of the active signals.
myScope.WriteString ":AUToscale"
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
on page 190
on page 196
on page 195
' Same as pressing Auto Scale key.
Chapter 41, "Programming Examples,"