Sbus<N>:Usb Commands - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

28
:SBUS<n> Commands
:SBUS<n>:USB Commands
These commands are only valid when a USB 2.0 triggering and serial decode option
N O T E
(Option USF or Option U2H) has been licensed.
Table 113 :SBUS<n>:USB Commands Summary
Command
:SBUS<n>:USB:BASE
<base> (see page
:SBUS<n>:USB:SOURce:D
MINus <source> (see
page 796)
:SBUS<n>:USB:SOURce:D
PLus <source> (see
page 797)
:SBUS<n>:USB:SOURce:D
IFFerential <source>
(see page 798)
:SBUS<n>:USB:SPEed
<speed> (see
page 799)
:SBUS<n>:USB:TRIGger
<condition> (see
page 800)
:SBUS<n>:USB:TRIGger:
ADDRess <string> (see
page 801)
792
Query
:SBUS<n>:USB:BASE?
795) (see page 795)
:SBUS<n>:USB:SOURce:D
MINus? (see
:SBUS<n>:USB:SOURce:D
PLus? (see page
:SBUS<n>:USB:SOURce:D
IFFerential? (see
page 798)
:SBUS<n>:USB:SPEed?
(see page 799)
:SBUS<n>:USB:TRIGger?
(see page 800)
:SBUS<n>:USB:TRIGger:
ADDRess? (see
page 801)
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
Options and Query Returns
<base> ::= {ASCii | BINary |
DECimal | HEX}
<source> ::= {CHANnel<n>} for DSO
page 796) models
<source> ::= {CHANnel<n> |
DIGital<d>} for MSO models
<n> ::= 1 to (# analog channels)
in NR1 format
<d> ::= 0 to (# digital channels
- 1) in NR1 format
<source> ::= {CHANnel<n>} for DSO
797) models
<source> ::= {CHANnel<n> |
DIGital<d>} for MSO models
<n> ::= 1 to (# analog channels)
in NR1 format
<d> ::= 0 to (# digital channels
- 1) in NR1 format
<source> ::= {CHANnel<n>}
<n> ::= 1 to (# analog channels)
in NR1 format
<speed> ::= {LOW | FULL | HIGH}
<condition> ::= {SOP | EOP |
ENTersuspend | EXITsuspend |
RESet | TOKen | DATA | HANDshake
| SPECial | ALLerrors | PIDerror
| CRC5error | CRC16error |
GLITcherror | STUFFerror |
SE1error}
<string> ::= "nnnnnnn" where n
::= {0 | 1 | X}
<string> ::= "0xnn" where n ::=
{0,..,9 | A,..,F | X | $}