Compliance:usb:run - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

:COMPliance:USB:RUN

Command Syntax
:COMPliance:USB:RUN
The :COMPliance:USB:RUN command runs the selected signal quality test.
Please be patient as tests can take several minutes to complete.
When tests are run, the oscilloscope stops acquisitions if they are running,
analyzes the data on screen, and then displays the results. The analyzed
acquisition remains on screen and can be viewed by moving or dismissing
the results dialog.
You can run tests when the oscilloscope is already stopped. This is useful
in the case of embedded hosts (and other cases) where the device under
test (DUT) may not easily be placed in a test mode, and you want to
analyze already acquired data.
See Also
•
•
•
•
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1208)
":COMPliance:USB:TEST"
":COMPliance:USB:AUTosetup"
"*OPC (Operation Complete)"
":SAVE:COMPliance:USB[:STARt]"
on page 290
on page 284
on page 172
on page 625
:COMPliance Commands
11
285