17
:FUNCtion<m> Commands
Introduction to
The FUNCtion subsystem controls the math functions in the oscilloscope.
:FUNCtion<m>
Four math functions are available — the <m> in :FUNCtion<m> can be from
Commands
1 to 4.
The math function operator, transform, filter, or visualization is selected
using the :FUNCtion<m>:OPERation command. Depending on the selected
operation, there may be other commands for specifying options for that
operation. See
The SOURce1, DISPlay, RANGe, and OFFSet (or REFerence) commands
apply to any function.
Reporting the Setup
Use :FUNCtion<m>? to query setup information for the FUNCtion
subsystem.
Return Format
The following is a sample response from the :FUNCtion1? query. In this
case, the query was issued following a *RST command.
:FUNC1:OPER ADD;DISP 0;SOUR1 CHAN1;SOUR2 CHAN2;RANG +8.00E+00;OFFS
+0.0E+00
340
":FUNCtion<m>:OPERation"
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
on page 358.