Power:quality:apply - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

:POWer:QUALity:APPLy

Command Syntax
:POWer:QUALity:APPLy
The :POWer:QUALity:APPLy command applies the selected power quality
analysis type (:POWer:QUALity:TYPE).
The power quality analysis shows the quality of the AC input line.
Some AC current may flow back into and back out of the load without
delivering energy. This current, called reactive or harmonic current, gives
rise to an "apparent" power which is larger than the actual power
consumed. Power quality is gauged by these measurements: power factor,
apparent power, true power, reactive power, crest factor, and phase angle
of the current and voltage of the AC line.
See Also
•
•
•
•
•
•
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1208)
":MEASure:FACTor" on page 495
":MEASure:REAL" on page 503
":MEASure:APParent"
":MEASure:REACtive"
":MEASure:CRESt" on page 492
":MEASure:ANGLe" on page 489
on page 490
on page 502
25
:POWer Commands
579