Wgen<W>:Output - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual
Oscilloscopes
Hide thumbs
Also See for InfiniiVision 4000 X-Series:
- User manual (486 pages) ,
- User manual (488 pages)
Table of Contents
Advertisement
34
:WGEN<w> Commands
:WGEN<w>:OUTPut
(see
page
1208)
Command Syntax
:WGEN<w>:OUTPut <on_off>
<w> ::= 1 or 2 in NR1 format
<on_off> ::= {{1 | ON} | {0 | OFF}
The :WGEN<w>:OUTPut command specifies whether the waveform
generator signal output is ON (1) or OFF (0).
Query Syntax
:WGEN<w>:OUTPut?
The :WGEN<w>:OUTPut? query returns the current state of the waveform
generator output setting.
Return Format
<on_off><NL>
<on_off> ::= {1 | 0}
See Also
•
"Introduction to :WGEN<w> Commands"
on page 1058
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
1085
Advertisement
Chapters
Table of Contents
