Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual page 397

:MARKer:X2Position
Command Syntax
:MARKer:X2Position <position> [suffix]
<position> ::= X2 cursor position in NR3 format
<suffix> ::= {s | ms | us | ns | ps | Hz | kHz | MHz}
The :MARKer:X2Position command:
• Sets :MARKer:MODE to MANual if it is not currently set to WAVeform
• Sets the X2 cursor position to the specified value.
X cursor units are set by the :MARKer:XUNits command.
Query Syntax
:MARKer:X2Position?
The :MARKer:X2Position? query returns current X2 cursor position. This is
functionally equivalent to the obsolete :MEASure:TSTOp command/query.
If the front-panel cursors are off, the marker position values are not defined and an error is
N O T E
generated. Make sure to set :MARKer:MODE to MANual or WAVeform to put the cursors in
the front-panel Normal mode.
Return Format
<position><NL>
<position> ::= X2 cursor position in NR3 format
See Also
•
•
•
•
•
•
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1208)
(see ":MARKer:MODE"
"Introduction to :MARKer Commands"
":MARKer:MODE" on page 394
":MARKer:X1Position"
":MARKer:X2Y2source"
":MARKer:XUNits" on page 400
":MEASure:TSTOp" on page 1143
on page 394).
on page 392
on page 395
on page 398
20
:MARKer Commands
397