Wgen<W>:Modulation:fm:deviation - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

:WGEN<w>:MODulation:FM:DEViation
Command Syntax
:WGEN<w>:MODulation:FM:DEViation <frequency>
<w> ::= 1 in NR1 format
<frequency> ::= frequency deviation in Hz in NR3 format
The :WGEN<w>:MODulation:FM:DEViation command specifies the frequency
deviation from the original carrier signal frequency.
When the modulating signal is at its maximum amplitude, the output
frequency is the carrier signal frequency plus the deviation amount, and
when the modulating signal is at its minimum amplitude, the output
frequency is the carrier signal frequency minus the deviation amount.
The frequency deviation cannot be greater than the original carrier signal
frequency.
Also, the sum of the original carrier signal frequency and the frequency
deviation must be less than or equal to the maximum frequency for the
selected waveform generator function plus 100 kHz.
Query Syntax
:WGEN<w>:MODulation:FM:DEViation?
The :WGEN<w>:MODulation:FM:DEViation? query returns the frequency
deviation setting.
Return Format
<frequency><NL>
<frequency> ::= frequency deviation in Hz in NR3 format
See Also
•
•
•
•
•
•
•
•
•
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1208)
":WGEN<w>:MODulation:AM:DEPTh"
":WGEN<w>:MODulation:AM:FREQuency"
":WGEN<w>:MODulation:FM:FREQuency"
":WGEN<w>:MODulation:FSKey:FREQuency"
":WGEN<w>:MODulation:FSKey:RATE"
":WGEN<w>:MODulation:FUNCtion"
":WGEN<w>:MODulation:FUNCtion:RAMP:SYMMetry"
":WGEN<w>:MODulation:STATe"
":WGEN<w>:MODulation:TYPE"
:WGEN<w> Commands
on page 1073
on page 1074
on page 1076
on page 1077
on page 1078
on page 1079
on page 1082
on page 1083
34
on page 1080
1075