Measure:vtop - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

21
:MEASure Commands

:MEASure:VTOP

Command Syntax
:MEASure:VTOP [<source>]
<source> ::= {CHANnel<n> | FUNCtion<m> | MATH<m>}
<n> ::= 1-2 or 1-4 (# of analog channels) in NR1 format
<m> ::= 1-4 in NR1 format
<r> ::= 1 to (# ref waveforms) in NR1 format
The :MEASure:VTOP command installs a screen measurement and starts a
waveform top value measurement.
This query is not available if the source is FFT (Fast Fourier Transform).
N O T E
Query Syntax
:MEASure:VTOP? [<source>]
The :MEASure:VTOP? query returns the vertical value at the top of the
waveform. The top value of the pulse is normally not the same as the
maximum value.
Return Format
<value><NL>
<value> ::= vertical value at the top of the waveform in NR3 format
See Also
•
•
•
•
•
480
(see page 1208)
"Introduction to :MEASure Commands"
":MEASure:SOURce"
":MEASure:VMAX" on page 474
":MEASure:VAMPlitude"
":MEASure:VBASe" on page 473
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
on page 420
on page 458
on page 471