Sbus<N>:I2S:clock:slope - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

28
:SBUS<n> Commands
:SBUS<n>:I2S:CLOCk:SLOPe
Command Syntax
:SBUS<n>:I2S:CLOCk:SLOPe <slope>
<slope> ::= {NEGative | POSitive}
The :SBUS<n>:I2S:CLOCk:SLOPe command specifies which edge of the I2S
serial clock signal clocks in data.
• NEGative — Falling edge.
• POSitive — Rising edge.
Query Syntax
:SBUS<n>:I2S:CLOCk:SLOPe?
The :SBUS<n>:I2S:CLOCk:SLOPe? query returns the current I2S clock slope
setting.
Return Format
<slope><NL>
<slope> ::= {NEG | POS}
See Also
•
•
•
•
•
708
(see page 1208)
"Introduction to :TRIGger Commands"
":SBUS<n>:I2S:ALIGnment"
":SBUS<n>:I2S:RWIDth"
":SBUS<n>:I2S:TWIDth"
":SBUS<n>:I2S:WSLow"
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
on page 935
on page 706
on page 709
on page 721
on page 722