Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual page 253

Utility commands for viewing calibration status and for starting the user
calibration procedure. See
page 254.
Table 84 :CALibrate Commands Summary
Command
n/a
:CALibrate:LABel
<string> (see
page 256)
:CALibrate:OUTPut
<signal> (see
page 257)
n/a
:CALibrate:STARt (see
page 259)
n/a
n/a
n/a
Agilent InfiniiVision 4000 X-Series Oscilloscopes
Programmer's Guide
9
:CALibrate Commands
"Introduction to :CALibrate Commands"
Query
:CALibrate:DATE? (see
page 255)
:CALibrate:LABel?
(see page 256)
:CALibrate:OUTPut?
(see page 257)
:CALibrate:PROTected?
(see page 258)
n/a
:CALibrate:STATus?
(see page 260)
:CALibrate:TEMPeratur
e? (see page 261)
:CALibrate:TIME? (see
page 262)
s1
Options and Query Returns
<return value> ::=
<year>,<month>,<day>; all in NR1
format
<string> ::= quoted ASCII string
up to 32 characters
<signal> ::= {TRIGgers | MASK |
WAVEgen | WGEN1 | WGEN2}
Note: WAVE and WGEN1 are
equivalent.
Note: WGEN2 only available on
models with 2 WaveGen outputs.
{PROTected | UNPRotected}
n/a
<return value> ::=
<status_code>,<status_string>
<status_code> ::= an integer
status code
<status_string> ::= an ASCII
status string
<return value> ::= degrees C
delta since last cal in NR3
format
<return value> ::=
<hours>,<minutes>,<seconds>; all
in NR1 format
on
253