Wgen<W>:Modulation:type - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

:WGEN<w>:MODulation:TYPE
Command Syntax
:WGEN<w>:MODulation:TYPE <type>
<w> ::= 1 in NR1 format
<type> ::= {AM | FM | FSK}
The :WGEN<w>:MODulation:TYPE command selects the modulation type:
• AM (amplitude modulation) — the amplitude of the original carrier
• FM (frequency modulation) — the frequency of the original carrier
• FSK (frequency- shift keying modulation) — the output frequency "shifts"
Query Syntax
:WGEN<w>:MODulation:TYPE?
The :WGEN<w>:MODulation:TYPE? query returns the selected modulation
type.
Return Format
<type><NL>
<type> ::= {AM | FM | FSK}
See Also
•
•
•
•
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1208)
signal is modified according to the amplitude of the modulating signal.
Use the :WGEN<w>:MODulation:AM:FREQuency command to set the
modulating signal frequency.
Use the :WGEN<w>:MODulation:AM:DEPTh command to specify the
amount of amplitude modulation.
signal is modified according to the amplitude of the modulating signal.
Use the :WGEN<w>:MODulation:FM:FREQuency command to set the
modulating signal frequency.
Use the :WGEN<w>:MODulation:FM:DEViation command to specify the
frequency deviation from the original carrier signal frequency.
between the original carrier frequency and a "hop frequency" at the
specified FSK rate.
The FSK rate specifies a digital square wave modulating signal.
Use the :WGEN<w>:MODulation:FSKey:FREQuency command to specify
the "hop frequency".
Use the :WGEN<w>:MODulation:FSKey:RATE command to specify the
rate at which the output frequency "shifts".
":WGEN<w>:MODulation:AM:DEPTh"
":WGEN<w>:MODulation:AM:FREQuency"
":WGEN<w>:MODulation:FM:DEViation"
":WGEN<w>:MODulation:FM:FREQuency"
:WGEN<w> Commands
on page 1073
on page 1074
on page 1075
on page 1076
34
1083