Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual page 396

20
:MARKer Commands
:MARKer:X1Y1source
Command Syntax
:MARKer:X1Y1source <source>
<source> ::= {CHANnel<n> | FUNCtion<m> | MATH<m> | WMEMory<r>}
<n> ::= 1 to (# analog channels) in NR1 format
<m> ::= 1-4 in NR1 format
<r> ::= 1 to (# ref waveforms) in NR1 format
The :MARKer:X1Y1source command sets the source for the cursors. The
channel you specify must be enabled for cursors to be displayed. If the
channel or function is not on, an error message is issued.
If the marker mode is not currently WAVeform (see
page 394):
• Sending a :MARKer:X1Y1source command will put the cursors in the
• Setting the source for one pair of markers (for example, X1Y1) sets the
If the marker mode is currently WAVeform, the X1Y1 source can be set
separate from the X2Y2 source.
If :MARKer:MODE is set to OFF or MANual, setting :MEASure:SOURce to
CHANnel<n>, FUNCtion, MATH, or WMEMory<r> will also set
:MARKer:X1Y1source and :MARKer:X2Y2source to this value.
MATH is an alias for FUNCtion. The query will return FUNC if the source is FUNCtion or
N O T E
MATH.
Query Syntax
:MARKer:X1Y1source?
The :MARKer:X1Y1source? query returns the current source for the
cursors. If all channels are off or if :MARKer:MODE is set to OFF, the
query returns NONE.
Return Format
<source><NL>
<source> ::= {CHAN<n> | FUNC | WMEM<r> | NONE}
See Also •
•
•
•
396
(see page 1208)
MANual mode.
source for the other (for example, X2Y2).
"Introduction to :MARKer Commands"
":MARKer:MODE" on page 394
":MARKer:X2Y2source"
":MEASure:SOURce"
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
on page 392
on page 398
on page 458
":MARKer:MODE" on