Search:serial:flexray:cycle - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

:SEARch:SERial:FLEXray:CYCLe

Command Syntax
:SEARch:SERial:FLEXray:CYCLe <cycle>
<cycle> ::= {ALL | <cycle #>}
<cycle #> ::= integer from 0-63
The :SEARch:SERial:FLEXray:CYCLe command specifies the cycle value to
find when searching for FlexRay frames.
A cycle value of - 1 is the same as ALL.
Query Syntax
:SEARch:SERial:FLEXray:CYCLe?
The :SEARch:SERial:FLEXray:CYCLe? query returns the current cycle value
setting.
Return Format
<cycle><NL>
<cycle> ::= {ALL | <cycle #>}
<cycle #> ::= integer from 0-63
See Also •
•
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1208)
Chapter 29, ":SEARch Commands," starting on page 817
":SEARch:SERial:FLEXray:MODE"
:SEARch Commands
on page 859
29
855