Wgen<W>:Modulation:state - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

34
:WGEN<w> Commands
:WGEN<w>:MODulation:STATe
Command Syntax
:WGEN<w>:MODulation:STATe <setting>
<w> ::= 1 in NR1 format
<setting> ::= {{OFF | 0} | {ON | 1}}
The :WGEN<w>:MODulation:STATe command enables or disables modulated
waveform generator output.
You can enable modulation for all waveform generator function types
except pulse, DC, and noise.
Query Syntax
:WGEN<w>:MODulation:STATe?
The :WGEN<w>:MODulation:STATe? query returns whether the modulated
waveform generator output is enabled of disabled.
Return Format
<setting><NL>
<setting> ::= {0 | 1}
See Also
•
•
•
•
•
•
•
•
•
1082
(see page 1208)
":WGEN<w>:MODulation:AM:DEPTh"
":WGEN<w>:MODulation:AM:FREQuency"
":WGEN<w>:MODulation:FM:DEViation"
":WGEN<w>:MODulation:FM:FREQuency"
":WGEN<w>:MODulation:FSKey:FREQuency"
":WGEN<w>:MODulation:FSKey:RATE"
":WGEN<w>:MODulation:FUNCtion"
":WGEN<w>:MODulation:FUNCtion:RAMP:SYMMetry"
":WGEN<w>:MODulation:TYPE"
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
on page 1073
on page 1074
on page 1075
on page 1076
on page 1077
on page 1078
on page 1079
on page 1083
on page 1080