Wgen<W>:Voltage:low - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

34
:WGEN<w> Commands
:WGEN<w>:VOLTage:LOW
Command Syntax
:WGEN<w>:VOLTage:LOW <low>
<w> ::= 1 or 2 in NR1 format
<low> ::= low-level voltage in volts, in NR3 format
For all waveforms except DC, the :WGEN<w>:VOLTage:LOW command
specifies the waveform's low- level voltage. Use the
:WGEN<w>:VOLTage:HIGH command to specify the high- level voltage.
You can also specify the high- level and low- level voltages indirectly using
the :WGEN<w>:VOLTage and :WGEN<w>:VOLTage:OFFSet commands. For
example, a high- level voltage of 4 V and a low- level voltage of - 1 V is the
same as an amplitude of 5 V and an offset of 1 V.
Query Syntax
:WGEN<w>:VOLTage:LOW?
The :WGEN<w>:VOLTage:LOW? query returns the currently specified
waveform low- level voltage.
Return Format
<low><NL>
<low> ::= low-level voltage in volts, in NR3 format
See Also •
•
•
•
•
1096
(see page 1208)
"Introduction to :WGEN<w> Commands"
":WGEN<w>:FUNCtion"
":WGEN<w>:VOLTage:LOW"
":WGEN<w>:VOLTage"
":WGEN<w>:VOLTage:OFFSet"
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
on page 1058
on page 1067
on page 1096
on page 1094
on page 1097