Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual page 402

20
:MARKer Commands
:MARKer:Y1Position
Command Syntax
:MARKer:Y1Position <position> [suffix]
<position> ::= Y1 cursor position in NR3 format
<suffix> ::= {mV | V | dB}
If the :MARKer:MODE is not currently set to WAVeform (see
":MARKer:MODE"
• Sets :MARKer:MODE to MANual.
• Sets the Y1 cursor position to the specified value.
Y cursor units are set by the :MARKer:YUNits command.
When the :MARKer:MODE is set to WAVeform, Y positions cannot be set.
Query Syntax
:MARKer:Y1Position?
The :MARKer:Y1Position? query returns current Y1 cursor position. This is
functionally equivalent to the obsolete :MEASure:VSTArt command/query.
If the front-panel cursors are off or are set to Binary or Hex Mode, the marker position
N O T E
values are not defined and an error is generated. Make sure to set :MARKer:MODE to
MANual or WAVeform to put the cursors in the front-panel Normal mode.
Return Format
<position><NL>
<position> ::= Y1 cursor position in NR3 format
See Also •
•
•
•
•
•
•
402
(see page 1208)
on page 394), the :MARKer:Y1Position command:
"Introduction to :MARKer Commands"
":MARKer:MODE" on page 394
":MARKer:X1Y1source"
":MARKer:X2Y2source"
":MARKer:Y2Position"
":MARKer:YUNits" on page 405
":MEASure:VSTArt" on page 1148
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
on page 392
on page 396
on page 398
on page 403