Pod<N>:Size - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

24
:POD Commands
:POD<n>:SIZE
Command Syntax
:POD<n>:SIZE <value>
<n> ::= An integer, 1 or 2, is attached as a suffix to the command and
POD1 ::= D0-D7
POD2 ::= D8-D15
<value> ::= {SMALl | MEDium | LARGe}
The :POD<n>:SIZE command specifies the size of digital channels on the
display. Sizes are set for all pods. Therefore, if you set the size on pod 1
(for example), the same size is set on pod 2 as well.
This command is only valid for the MSO models.
N O T E
Query Syntax
:POD<n>:SIZE?
The :POD<n>:SIZE? query returns the digital channels size setting.
Return Format
<size_value><NL>
<size_value> ::= {SMAL | MED | LARG}
See Also •
•
•
544
(see page 1208)
defines the group of channels that are affected by the command.
"Introduction to :POD<n> Commands"
":DIGital<d>:SIZE" on page 306
":DIGital<d>:POSition"
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
on page 541
on page 305