Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual page 680

28
:SBUS<n> Commands
CAN Id specification is set by the :SBUS<n>:CAN:TRIGger:PATTern:ID
and:SBUS<n>:CAN:TRIGger:PATTern:ID:MODE commands.
CAN Data specification is set by the :SBUS<n>:CAN:TRIGger:PATTern:DATA
command.
CAN Data Length Code is set by the
:SBUS<n>:CAN:TRIGger:PATTern:DATA:LENGth command.
Query Syntax
:SBUS<n>:CAN:TRIGger?
The :SBUS<n>:CAN:TRIGger? query returns the current CAN trigger on
condition.
Return Format
<condition><NL>
<condition> ::= {SOF | DATA | ERR | IDD | IDE | IDR | ALL | OVER | ACK}
Errors
•
See Also
•
•
•
•
•
•
•
•
680
"- 241, Hardware missing"
"Introduction to :SBUS<n> Commands"
":SBUS<n>:MODE" on page 649
":SBUS<n>:CAN:TRIGger:PATTern:DATA"
":SBUS<n>:CAN:TRIGger:PATTern:DATA:LENGth"
":SBUS<n>:CAN:TRIGger:PATTern:ID"
":SBUS<n>:CAN:TRIGger:PATTern:ID:MODE"
":SBUS<n>:CAN:SIGNal:DEFinition"
":SBUS<n>:CAN:SOURce"
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
on page 1169
on page 645
on page 681
on page 683
on page 684
on page 677
on page 678
on page 682