Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual page 407

Select automatic measurements to be made and control time markers. See
"Introduction to :MEASure Commands"
Table 96 :MEASure Commands Summary
Command
:MEASure:ALL (see
page 422)
:MEASure:AREa
[<interval>][,<source
>] (see page 423)
:MEASure:BWIDth
[<source>] (see
page 424)
:MEASure:CLEar (see
page 425)
Agilent InfiniiVision 4000 X-Series Oscilloscopes
Programmer's Guide
21
:MEASure Commands
Query
n/a
:MEASure:AREa?
[<interval>][,<source
>] (see page 423)
:MEASure:BWIDth?
[<source>] (see
page 424)
n/a
s1
on page 420.
Options and Query Returns
n/a
<interval> ::= {CYCLe | DISPlay}
<source> ::= {CHANnel<n> |
FUNCtion<m> | MATH<m> |
WMEMory<r>}
<n> ::= 1 to (# analog channels)
in NR1 format
<m> ::= 1-4 in NR1 format
<r> ::= 1 to (# ref waveforms) in
NR1 format
<return_value> ::= area in
volt-seconds, NR3 format
<source> ::= {CHANnel<n> |
FUNCtion<m> | MATH<m> |
WMEMory<r>}
<n> ::= 1 to (# analog channels)
in NR1 format
<m> ::= 1-4 in NR1 format
<r> ::= 1 to (# ref waveforms) in
NR1 format
<return_value> ::= burst width in
seconds, NR3 format
n/a
407