Trigger:delay Commands - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

:TRIGger:DELay Commands

Table 132 :TRIGger:DELay Commands Summary
Command
:TRIGger:DELay:ARM:SL
OPe <slope> (see
page 948)
:TRIGger:DELay:ARM:SO
URce <source> (see
page 949)
:TRIGger:DELay:TDELay
:TIME <time_value>
(see page 950)
:TRIGger:DELay:TRIGge
r:COUNt <count> (see
page 951)
:TRIGger:DELay:TRIGge
r:SLOPe <slope> (see
page 952)
:TRIGger:DELay:TRIGge
r:SOURce <source>
(see page 953)
The :TRIGger:DELay:ARM:SOURce and :TRIGger:DELay:TRIGger:SOURce
commands are used to specify the source channel for the arming edge and
the trigger edge in the Edge Then Edge trigger.
If an analog channel is selected as a source, the :TRIGger:EDGE:LEVel
command is used to set the trigger level.
If a digital channel is selected as the source, the :DIGital<n>:THReshold or
:POD<n>:THReshold command is used to set the trigger level.
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
Query
:TRIGger:DELay:ARM:SL
OPe? (see page 948)
:TRIGger:DELay:ARM:SO
URce? (see page 949)
:TRIGger:DELay:TDELay
:TIME? (see page 950)
:TRIGger:DELay:TRIGge
r:COUNt? (see
page 951)
:TRIGger:DELay:TRIGge
r:SLOPe? (see
page 952)
:TRIGger:DELay:TRIGge
r:SOURce? (see
page 953)
:TRIGger Commands
Options and Query Returns
<slope> ::= {NEGative | POSitive}
<source> ::= {CHANnel<n> |
DIGital<d>}
<n> ::= 1 to (# analog channels)
in NR1 format
<d> ::= 0 to (# digital channels
- 1) in NR1 format
<time_value> ::= time in seconds
in NR3 format
<count> ::= integer in NR1 format
<slope> ::= {NEGative | POSitive}
<source> ::= {CHANnel<n> |
DIGital<d>}
<n> ::= 1 to (# analog channels)
in NR1 format
<d> ::= 0 to (# digital channels
- 1) in NR1 format
32
947