In Nr1 Format (With Option Sgm) - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

When the built- in waveform generator is licensed (Option WGN), you can
use it to output sine, square, ramp, pulse, DC, noise, sine cardinal,
exponential rise, exponential fall, cardiac, and gaussian pulse waveforms.
The :WGEN<w> commands are used to select the waveform function and
parameters. See
Table 145 :WGEN<w> Commands Summary
Command
:WGEN<w>:ARBitrary:BY
Teorder <order> (see
page 1?59)
:WGEN<w>:ARBitrary:DA
TA {<binary> |
<value>, <value> ...}
(see page 1060)
n/a
:WGEN<w>:ARBitrary:DA
TA:CLEar (see
page 1062)
:WGEN<w>:ARBitrary:DA
TA:DAC {<binary> |
<value>, <value> ...}
(see page 1063)
:WGEN<w>:ARBitrary:IN
Terpolate {{0 | OFF}
| {1 | ON}} (see
page 1064)
Agilent InfiniiVision 4000 X-Series Oscilloscopes
Programmer's Guide
34
:WGEN<w> Commands
"Introduction to :WGEN<w> Commands"
Query
:WGEN<w>:ARBitrary:BY
Teorder? (see
page 1059)
n/a
:WGEN<w>:ARBitrary:DA
TA:ATTRibute:POINts?
(see page 1061)
n/a
n/a
:WGEN<w>:ARBitrary:IN
Terpolate? (see
page 1064)
s1
Options and Query Returns
<order> ::= {MSBFirst | LSBFirst}
<w> ::= 1 or 2 in NR1 format
<binary> ::= floating point
values between -1.0 to +1.0 in
IEEE 488.2 binary block format
<value> ::= floating point values
between -1.0 to +1.0 in
comma-separated format
<w> ::= 1 or 2 in NR1 format
<points> ::= number of points in
NR1 format
<w> ::= 1 or 2 in NR1 format
<w> ::= 1 or 2 in NR1 format
<binary> ::= decimal 16-bit
integer values between -512 to
+511 in IEEE 488.2 binary block
format
<value> ::= decimal integer
values between -512 to +511 in
comma-separated NR1 format
<w> ::= 1 or 2 in NR1 format
{0 | 1}
<w> ::= 1 or 2 in NR1 format
on page 1058.
1055