Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual page 165

*CLS (Clear Status)
Command Syntax
*CLS
The *CLS common command clears the status data structures, the
device- defined error queue, and the Request- for- OPC flag.
If the *CLS command immediately follows a program message terminator, the output queue
N O T E
and the MAV (message available) bit are cleared.
See Also
•
•
•
•
•
•
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1208)
"Introduction to Common (*) Commands"
"*STB (Read Status Byte)"
"*ESE (Standard Event Status Enable)"
"*ESR (Standard Event Status Register)"
"*SRE (Service Request Enable)"
":SYSTem:ERRor" on page 913
on page 164
on page 182
on page 166
on page 168
on page 180
Common (*) Commands
165
5