Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual page 178

5
Common (*) Commands
Trigger Menu
HF Reject and noise reject
Holdoff
External probe attenuation
External Units
External Impedance
See Also
•
•
Example Code
See complete example programs at:
starting on page 1217
178
"Introduction to Common (*) Commands"
":SYSTem:PRESet" on page 915
' RESET - This command puts the oscilloscope into a known state.
' This statement is very important for programs to work as expected.
' Most of the following initialization commands are initialized by
' *RST. It is not necessary to reinitialize them unless the default
' setting is not suitable for your application.
myScope.WriteString "*RST"
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
Off
40 ns
10:1
Volts
1 M Ohm (cannot be changed)
on page 164
' Reset the oscilloscope to the defaults.
Chapter 41, "Programming Examples,"