Search:serial:can:pattern:id:mode - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

:SEARch:SERial:CAN:PATTern:ID:MODE

Command Syntax
:SEARch:SERial:CAN:PATTern:ID:MODE <value>
<value> ::= {STANdard | EXTended}
The :SEARch:SERial:CAN:PATTern:ID:MODE command specifies whether a
standard ID value or an extended ID value is used when searching for a
CAN event.
The ID value is specified using the :SEARch:SERial:CAN:PATTern:ID
command.
Query Syntax
:SEARch:SERial:CAN:PATTern:ID:MODE?
The :SEARch:SERial:CAN:PATTern:ID:MODE? query returns the current
setting.
Return Format
<value><NL>
<value> ::= {STAN | EXT}
See Also
•
•
•
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1208)
Chapter 29, ":SEARch Commands," starting on page 817
":SEARch:SERial:CAN:MODE"
":SEARch:SERial:CAN:PATTern:ID"
on page 849
on page 852
29
:SEARch Commands
853