Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual page 405

:MARKer:YUNits
Command Syntax
:MARKer:YUNits <units>
<units> ::= {BASE | PERCent}
The :MARKer:YUNits command sets the Y cursors units:
• BASE — for making measurements in the units associated with the
• PERCent — for making ratio measurements. Use the
Changing Y units affects the input and output values of the
:MARKer:Y1Position, :MARKer:Y2Position, and :MARKer:YDELta
commands/queries.
Query Syntax
:MARKer:YUNits?
The :MARKer:YUNits? query returns the current Y cursors units.
Return Format
<units><NL>
<units> ::= {BASE | PERC}
See Also •
•
•
•
•
•
•
•
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1208)
cursors source.
:MARKer:YUNits:USE command to set the current Y1 location as 0
percent and the current Y2 location as 100 percent.
"Introduction to :MARKer Commands"
":MARKer:YUNits:USE"
":MARKer:X1Y1source"
":MARKer:X2Y2source"
":MEASure:SOURce"
":MARKer:Y1Position"
":MARKer:Y2Position"
":MARKer:YDELta" on page 404
on page 392
on page 406
on page 396
on page 398
on page 458
on page 402
on page 403
20
:MARKer Commands
405