Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual page 250

8
:BUS<n> Commands
:BUS<n>:LABel
Command Syntax
:BUS<n>:LABel <quoted_string>
<quoted_string> ::= any series of 10 or less characters as a
quoted ASCII string.
<n> ::= An integer, 1 or 2, is attached as a suffix to BUS
and defines the bus that is affected by the command.
The :BUS<n>:LABel command sets the bus label to the quoted string.
Setting a label for a bus will also result in the name being added to the
label list.
This command is only valid for the MSO models.
N O T E
Label strings are 10 characters or less, and may contain any commonly used ASCII
N O T E
characters. Labels with more than 10 characters are truncated to 10 characters.
Query Syntax
:BUS<n>:LABel?
The :BUS<n>:LABel? query returns the name of the specified bus.
Return Format
<quoted_string><NL>
<quoted_string> ::= any series of 10 or less characters as a
quoted ASCII string.
See Also •
•
•
•
•
•
•
•
•
Example Code
' Set the bus 1 label to "Data":
myScope.WriteString ":BUS1:LABel 'Data'"
250
(see page 1208)
"Introduction to :BUS<n> Commands"
":BUS<n>:BIT<m>" on page 245
":BUS<n>:BITS" on page 246
":BUS<n>:CLEar" on page 248
":BUS<n>:DISPlay" on page 249
":BUS<n>:MASK" on page 251
":CHANnel<n>:LABel"
":DISPlay:LABList" on page 318
":DIGital<d>:LABel" on page 304
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
on page 244
on page 271