:RECall:ARBitrary[:STARt]
Command Syntax
:RECall:ARBitrary:[STARt] [<file_spec>][, <column>][, <wavegen_id>]
<file_spec> ::= {<internal_loc> | <file_name>}
<column> ::= Column in CSV file to load. Column number starts from 1.
<wavegen_id> ::= {WGEN1 | WGEN2} - specifies which wavegen
<internal_loc> ::= 0-3; an integer in NR1 format
<file_name> ::= quoted ASCII string
The :RECall:ARBitrary:[STARt] command recalls an arbitrary waveform.
If a file extension is provided as part of a specified <file_name>, it must be ".csv".
N O T E
For internal locations, the <column> parameter is ignored.
For external (USB storage device) files, the column parameter is optional.
If no <column> parameter is entered, and it is a 2- column file, the 2nd
column (assumed to be voltage) is automatically be selected. If the
<column> parameter is entered, and that column does not exist in the file,
the operation fails.
When recalling arbitrary waveforms (from an external USB storage device)
that were not saved from the oscilloscope, be aware that the oscilloscope
uses a maximum of 8192 points for an arbitrary waveform. For more
efficient recalls, make sure your arbitrary waveforms are 8192 points or
less.
The <wavegen_id> parameter specifies which waveform generator to recall
the arbitrary waveform into.
See Also
•
•
•
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see
page
1208)
"Introduction to :RECall Commands"
":RECall:FILename"
on page 616
":SAVE:ARBitrary[:STARt]"
on page 614
on page 624
26
:RECall Commands
615