Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual page 209

:OPEE (Operation Status Enable Register)
Command Syntax
:OPEE <mask>
<mask> ::= 15-bit integer
The :OPEE command sets a mask in the Operation Status Enable register.
Set any of the following bits to "1" to enable bit 7 in the Status Byte
Register and potentially cause an SRQ (Service Request) interrupt to be
generated.
From Hardware
Event Registers
OR
To OPER bit in
Status Byte
Register
Table 77 Operation Status Enable Register (OPEE)
Bit
14
13
12
11
10
9
8-6
5
4
3
2-0
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1208)
From Overload From Mask Test
Event Registers Event Registers
IOF IOC HWE
OVLR MTE
14 13 12 11 9
IOF IOC HWE OVLR MTE
14 13 12 11 10 9 8
+
Name Description
IOF IO Operation Failed
IOC IO Operation Complete
HWE Hardware Event
OVLR Overload
--- ---
MTE Mask Test Event
--- ---
Wait Wait Trig
Trig
--- ---
Run Running
--- ---
Arm
AER?
Reg
Run bit set if oscilloscope not stopped
Wait
:OPEReration:CONDition?
Run
Trig
Operation Status Condition Register
5 3
Wait :OPERation[:EVENt]?
Run
Trig
Operation Status Event Register
7 6 5 4 3 2 1 0
:OPEE
:OPEE?
Operation Status Enable
(Mask) Register
When Set (1 = High = True), Enables:
Event when the IO operation fails.
Event when the IO operation completes.
Event when hardware event occurs.
Event when 50 input overload occurs.
(Not used.)
Event when mask test event occurs.
(Not used.)
Event when the trigger is armed.
(Not used.)
Event when the oscilloscope is running (not
stopped).
(Not used.)
6
Root (:) Commands
209