Sbus<N>:Uart:trigger:type - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

28
:SBUS<n> Commands
:SBUS<n>:UART:TRIGger:TYPE
Command Syntax
:SBUS<n>:UART:TRIGger:TYPE <value>
<value> ::= {RSTArt | RSTOp | RDATa | RD1 | RD0 | RDX | PARityerror
The :SBUS<n>:UART:TRIGger:TYPE command selects the UART trigger type.
When one of the RD or TD types is selected, the
:SBUS<n>:UART:TRIGger:DATA and :SBUS<n>:UART:TRIGger:QUALifier
commands are used to specify the data value and comparison operator.
The RD1, RD0, RDX, TD1, TD0, and TDX types (for triggering on data and
alert bit values) are only valid when a 9- bit width has been selected.
Query Syntax
:SBUS<n>:UART:TRIGger:TYPE?
The :SBUS<n>:UART:TRIGger:TYPE? query returns the current UART
trigger data value.
Return Format
<value><NL>
<value> ::= {RSTA | RSTO | RDAT | RD1 | RD0 | RDX | PAR | TSTA |
See Also
•
•
•
•
•
790
(see page 1208)
| TSTArt | TSTOp | TDATa | TD1 | TD0 | TDX}
TSTO | TDAT | TD1 | TD0 | TDX}
"Introduction to :TRIGger Commands"
":TRIGger:MODE" on page 944
":SBUS<n>:UART:TRIGger:DATA"
":SBUS<n>:UART:TRIGger:QUALifier"
":SBUS<n>:UART:WIDTh"
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
on page 935
on page 787
on page 789
on page 791