Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual page 406

20
:MARKer Commands
:MARKer:YUNits:USE
Command Syntax
:MARKer:YUNits:USE
When PERCent is selected for :MARKer:YUNits, the :MARKer:YUNits:USE
command sets the current Y1 location as 0 percent and the current Y2
location as 100 percent.
Once the 0 and 100 percent locations are set, inputs to and outputs from
the :MARKer:Y1Position, :MARKer:Y2Position, and :MARKer:YDELta
commands/queries are relative to the set locations.
See Also
•
•
•
•
•
•
•
•
406
(see page 1208)
"Introduction to :MARKer Commands"
":MARKer:YUNits" on page 405
":MARKer:X1Y1source"
":MARKer:X2Y2source"
":MEASure:SOURce"
":MARKer:Y1Position"
":MARKer:Y2Position"
":MARKer:YDELta" on page 404
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
on page 392
on page 396
on page 398
on page 458
on page 402
on page 403