Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual page 1112

36
Obsolete and Discontinued Commands
Obsolete Command
:MTESt:RUMode (see
page
:MTESt:RUMode:SOFailure
(see
:MTESt:{STARt | STOP} (see
page
:MTESt:TRIGger:SOURce (see
page
:PRINt? (see
:SAVE:IMAGe:AREA (see
page
:TIMebase:DELay (see
page
:SBUS<n>:LIN:SIGNal:DEFiniti
on (see
:SBUS<n>:SPI:SOURce:DATA
(see
:SYSTem:MENU (see
page
:TRIGger:THReshold (see
page
:TRIGger:TV:TVMode (see
page
Discontinued
Discontinued commands are commands that were used by previous
Commands oscilloscopes, but are not supported by the InfiniiVision 4000 X- Series
oscilloscopes. Listed below are the Discontinued commands and the
nearest equivalent command available (if any).
1112
1154)
page 1155)
1156)
1157)
page 1158)
1160)
1164)
page 1161)
page 1162)
1163)
1165)
1166)
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
Current Command Equivalent
:MTESt:RMODe (see
page 526)
:MTESt:RMODe:FACTion:STO
P (see page 530)
:RUN (see page 220) or :STOP
(see page 224)
:TRIGger Commands (see
page 935)
:DISPlay:DATA? (see
page 316)
none
:TIMebase:POSition (see
page 926) or
:TIMebase:WINDow:POSition
(see page 932)
none
:SBUS<n>:SPI:SOURce:MOSI
(see page 763)
:DISPlay:MENU (see
page 319)
:POD<n>:THReshold (see
page 545) or
:DIGital<d>:THReshold (see
page 307)
:TRIGger:TV:MODE (see
page 1004)
Behavior Differences
There are various commands
for setting the source with
different types of triggers.
TIMebase:POSition is position
value of main time base;
TIMebase:WINDow:POSition
is position value of zoomed
(delayed) time base window.
No change in behavior.